Check Engine Light
I just completed a rebuild on my 07 Can Am 650 Outlander. Motor runs great now, the only problem is that when I take off in two wheel drive I only make it about 1/4 mile and the 4x4 light will flash a couple of times and then the engine light comes on. It will either say check engine or limp home. Once I shut the quad off and then restart it the light will stay off. If I start off in 4x4 I do not get any engine lights or any kind of code. After the quad has gone maybe 1/2 mile I can switch back into two wheel and I get no codes at all.
Does anyone have any suggestions.