Heres some directions for the limiter.
1- remove seat & plastic piece under seat.
2-jack the rear of the quad up so both rear tires are off the ground.
3-remove right rear wheel & tire.
4-remove lower shock bolt & install the limiter, the part with the hole in it & reinstall shock bolt.
5-install wheel & tire & lower quad back to the ground.
6-install the eyebolt thru the hole behind the the shock support as shown in picture above.You may have to push down on the quad to get the eye bolt thru or have someone sit on the back of the quad.
7-install the washer & lock nut.Dont run the nut all the way down just till it gets on the nylon.
8-jack the quad back up and measure center of shock bolt to center of shock bolt.19'' is what you need.adj. eyebolt untill you get 19''
any questions call 706-931-2513 Ed
|
05-17-2007, 05:31 PM
Linear Mode
