Search Results for ‘650’

https://kapwi.ng/c/c55aiMSjeK Does anyone know why my clutch is making that noise in the video above? ANY help would be appreciated, it’s an 07 OUTLANDER 650

I bought a new carb for my 650 but it doesn't have the little piece that the throttle cable screws on to. Does anyone know the name of the part?

Hello everyone, I am a Raptor 700 owner for the last two years, these automatic atvs are a whole different world for me. My rap is a simple 10W40 oil change ever 10 hours, clean oil filter, grease. Done. Person I bought the outlander off was great but I forgot everything he said. It is a...

Little trip to sicamous b.c Canada

Can’t find where to put the solenoid on my 650 outlander xmr if anyone could help would be greatly appreciated. Watched tons of videos on 570s because I could not find any 650 winch installation videos.

Good afternoon, I have a 2020 can am 650 xmr, what I’m wondering is whether or not if it’s possible with a 2020 and would I have to swap the differentials as well? Any help would be appreciated thanks.

Bought this bike used 2 days ago, i absolutely love the power and how smooth it is. I’m having a misfire issue, has slight misfire at idle and you can heard it clearly, and under light throttle. When you’re full pin or higher speed there is no misfire. Worse when it’s colder but still notice...

Bought this bike used 2 days ago, i absolutely love the power and how smooth it is. I’m having a misfire issue, has slight misfire at idle and you can heard it clearly, and under light throttle. When you’re full pin or higher speed there is no misfire. Worse when it’s colder but still notice...

Hi, I was thinking about getting a Looney Tuned Exhaust slip on for my Can Am Outlander 2018 650, I dont want to buy a fuel tuner because of the cost, do I need one for a 650, I understand a tuner for a 1000 would be good to have, but do I need it? Im not looking for any horsepower gains, just...

I am looking for confirmation on the Primary one way clutch bearings for the 2002 can-am quest 650. The shop manual lists these OEM parts based on the diagram on page 03-11-1 Primary Clutch on the Right side OEM BALL BEARING 711632370 I don't think you need to replace these on the secondary...

I own a 2002 Can-Am Quest 650. It will start if you massage the throttle a bit and it will continue to run. BUT if you let go of the throttle and try to let it idle it will always die warm or cold. It has Non-Oxy premium gas, a new gapped NGK plug, a good CVT belt, a new carb (as of today) and...

looking for a rear diff for my 2013 xmr 650. please let me know if anyone has one! thank you!

OK so here's my story.. I got a 2010 650 max XT. it has a duel looney toon exhaust, looney toon programed, works shocks, snorkel kit. still on stock tires, now my question is.... when I go deep in the mud hole, exhaust under water deep, Goin slow cause of the mud... I'm watching my RPM's...

So while washing my machine yesterday I noticed a vent line hanging, it appeared to be burnt off by the exhaust, I'm not sure what it vents but it's located on the right front of the engine, does anyone know if this could have sucked up some water or mud? And what vent would this be, thanks guys!

Hi I recently purchased a well used Bombardier Quest Max 650 and it had no obvious problems when we checked it out and tested it. After riding for a little over 5 hours on a trailer and surviving a 60 mph blowout of one of the trailer tires we got it home. We could smell a little gas driving it...

I have a 09 650 outlander. It is slow revving with slow throttle response in idle and when in gear in has a slow reaction time and take off till it hits higher rpms. Does anybody now what could be causing this could it be anything to do the the cvt. Or could the fuel tunner be messing up?

I have an 07 650 Outlander that will run on starting fluid only. It has set up for almost a year without being ran. Put a new drive belt and primary clutch bearings on it and moved to the fuel system. I started with draining the fuel tank and lines. then moved to a new air filter. When I try to...

Hi. I'm a noob. I was just given a 2008 Can-Am Outlander 650 XT (with winch). I'm looking for a plow that will work with it. This one is for sale on craigslist. 52" Can AM - ATV Snow Plow Any idea if this one will work with my 650? The seller said that his plow was sold to him along...

Any problem with running in 4WD for an extended amount of time? Got 4 inches of snow here and wanna take the quad out to do some sledding?

My outlander 650 refuses to go into reverse and grinds in every other gear. i took the belt cover off and seen grease. decided to take the right gear off, and it looks like a bearing or something is shot. any ideas? :tools1: