axle

I'm having issues with a few things on my SXS. 1. the nut on the rear axle pulling out even with red lock tight 2. Tie rod ends snapping and pulling my cv's out of my axles even at low speeds. I have upgraded to the wicked built power steering and 2.0 steering box with built in steel tie rods...

I have a 2005 outlander 400, The left axle will not stop popping out of the inter joint. The groves in the inter joint are a little wear , but I don't see how that will be a problem. I don't know what going on and could use some help.. please....

Just bought my 4" lift, and put it on and I am breaking acles constantly. I'm looking to buy turner axlra for my machine, but they only have the old style lift kit acle specs. Since this is the upgraded kit I need to find out what the specs are for these axles. Any help is appreciated.

I’m looking to upgrade the axles on my 2008 Max 800. I’m an aggressive rider and I put the Kenda Bearclaw HTR’s on it. After a good riding season with the tires the right rear axle snapped. I’ve been looking around the web and there are several options so I’m looking for some feedback...

well i put a highlifter 2'' lift on my bike a couple months ago and the first day i had it on about. 5 mins after we were finished i broke it riding a wheelie because we didnt put the spacer that came with the lift. so after that i bought a highlifter outlaw axle and put the spacer and...

Found in my garage.... compliments of my cheating ex. Can someone help me figure out what this is? It says Bombardier. The left side has these numbers: 105100028-F. I cannot figure out the part number on the left. I want to sell it but need to know what it goes on. It appears to be Traxter rear...

I know it's not a can am but I think you guys could help. This past weekend I went on a ride in my stock 2012 yamaha rhino. There was a little bit of mud but nothing terrible. Today after I washed it I noticed a knocking noise in the left side rear end. It knocks when in reverse and when...

I have a 2008 DS 450X, and I destroyed my carrier bearings. I am wondering if anyone knows of a good upgraded setup for the carrier, bearings, axle, and sprocket. I figure that if I am going to tear it apart I might as well do it all.

Seen a few ways to pull axles (dead blow hammer, straps etc). Thought I'd throw in my 2cents worth on the subject. I get a big ass thick stainless hose clamp which goes over which ever axle CV that needs pulling. Then I have a lenght of seatbelt that I have used RTV on the ends about 2 inches...

Iv got a 2002 bombardier ds650 Baja and I'm in need of a new axle. Does anyone know where I could buy a cheaper one? Or someone who's parting out a ds? I'm also looking for a arms and an exhaust for the right price. Someone please help! 👍

Hi forum... Just would like some advice on how to remove my front axle to change the cv boot??? Thanks

All, In my quest for not cashing out the bank to buy a complete axle just so I will stop breaking the CV Joint cages under minor conditions, I have come across a group buy where we can get Chrome Moly or even better cages & balls built to OEM specs for the Outlander 800. Thus, we can keep...

Hey guys, has anyone come across this before. I brought my bike in (2007 800 xt) for the 100hr. service and to change the inner cv boot on the right rear axle. It has been there for a few days and one of the technicians called me up today and said that I am going to have to replace the whole...