Can-Am ATV Forum banner

brake

  1. Brake Pedal Freezes when pushed down

    BRP Traxter / Quest
    Hi All, I have a bombardier Traxter Max 500 2003. My foot pedal when pushed down, stays in the down position and will only come up if I pull it up by hand. My left hand brake is extremely hard to set the back break. When the pedal is down, then i have no tension at all in the left hand brake...
  2. Rear Brakes Weak

    Can-Am Renegade
    Hello, I just finished changing the brake pads on my 2012 Renegade 1000 XXC. I notice my rear brakes don't brake very well, i.e. won't lock up like the fronts. Basically the rear brake just gradually slows the bike down and doesn't bite like the front. The lever isn't squishy, there is...
  3. Problem filling brake system

    Can-Am Service Bulletins /Recalls / How To
    Hello. I am having trouble filling my 2011 Renegade 800 offroad braking system. I am doing it by the book but still get air in the system so there’s something I am not doing right. It is a complex system with front/rear pressure splitters on both sides. Filling one side causes air to leak into...
  4. Front axles, rear brake pads, XMR rear floorboards, skidplate, trailing arm

    Can-Am Outlander
    $300 shipped for pair -Basically new front axles from a 2012 XMR, replaced almost immediately with Gorilla Axles, less than 50 miles $20 shipped - Race Driven Rear Brake pads, again for 2012 XMR, should fit many other years and models check with Race Driven $10 + shipping - Factory Plastic...
  5. why cant I start my 2013 commander in gear?

    Can-Am Commander
    Why cant i start my 2013 commander in gear with the brakes applied? the brake lights dont work either. all fuses are good. the relay tested good. i tried unplugging the pressure switch and completing the circuit on the harness and still nothing. are the brakes set up in a continuous circuit...
  6. 2011 outlander brakes?

    Can-Am Outlander
    i have a 2011 outlander just have one question. When you apply the hand brake on the handle bar in 2wheel drive or even in 4wheel high it makes a grinding like sound till you stop almost like the discs are wet type sound ??? But if you where to put it in 4 low in 4wheel drive it does not make...
  7. brake pad problem

    Can-Am Outlander
    Trying to replace my brake pads. Does anyone know why I can't push the brake cylinder back in? I have tried several times with a C clamp cranking down on the old pad, but it won't budge. I squeezed the brake and it moves out fine, but not in. It wouldn't move in the first position, then...
Top