Search Results for ‘brakes’

Hi, The hand brake most likely goes through the ABS module and therefore I cannot blead the line going to the rear brakes. Anyone knows how to do that or does it require BUDS? br, Vidar

I need to replace the front left caliper on my 2019 outlander xtp. I am not planning on dropping the $180 for OEM. I have seen cheap 3 packs got around $100. My question is, has anyone had experience with aftermarket caliper? Are they a viable replacement for OEM? And should I change all three...

Hi good afternoon, my outlander 1000 xmr has the break always on, and doesn’t accelerate, I already check the brakes, brake fluid, and fuse box and still appear the light check ((p))

Hey guys, I just picked up my second hand 2016 570 Outlander Max XT and took it for its first ride this weekend. It was AWESOME! Power seemed more than enough lol. Lots of fun out in the snow. When it came to breaking with the hand lever, it felt possibly a little underwhelming. Like it might...

I have 12 outty 800r efi xt and i need a right front brake caliper and am on a tight budget so i was looking at aftermarket calipers but need to get it going so i can go hunting!!!! Also any thoughts on All Balls wheel bearings and what brake pads you reccomend????? THANK YOU FOR ANY...

So I replaced my front brake pads today after my originals were shot. Everything installed fine but now it seems like the brakes pads are rubbing. Is there something I did wrong or a way to make sure the pressure is releasing? Thanks in advance

Hi guys, I have been looking all over the place for info on replacing the rotors on my Outty. Can't find ANYTHING. :th_smiliefrustrated its a 2007 800 XT Ltd. all i can find is info on the brake pads. Has ANYONE done this? Seems like its an involved process, and so i don't wanna go into it...

Got about 4 inches of snow here and was out riding in 2wd drifting and was going about 30mph on roads that were plowed but covered in thin layer of ice and i took off throttle and it got to about 15 and i just slid and bout hit a mailbox. Is the engine brake suppose to be that strong and just...

Any suggestions? Stripped screw on master cylinder so i tried drilling the head off, got it off but accidently went into the aluminum and the other half is still stuck in the threads? Got some metal shaving in the cylinder so i drained and got them out. Left the other screw in and just taped up...

:tools1:Weak break light operation! and not being able to start bike in gear unless you pull quite hard on brake. the stock break switch located on the master cyl on the frame is designed to make continuity at 60PSI, I have found another switch that work well in it palce engaging at 35 PSI...

As some may know the braking setup on the '07 renegade 800 has only one handle on the left side of the handlebar. I have only had the bike for about a month and have recently come to realize that when riding and enjoying a beverage with lots of power things become sketchy quick. After being...