Search Results for ‘can am outlander’

so i have a 2010 can am outlander 800xt. it was swamped so pulled it home and did all the nessary stuff, pull plugs. Drain oil, oil changes etc. i had water in my gas so i pulled the lines off the injector, and cranked over until gas was gone.. then the next day i go to start my quad and starter...

I bought this fourwheeler like a week ago, and it runs fine, only 1100 miles and shifted fine. Yesterday I went to shift into low and it went into high and this is what it does. when I go to shift in park and reverse it’s fine but if I shift into neutral it shows on the digital screen that I am...

I’ve got a 2018 Renegade that occasionally won’t start.. it will start 10x in a row then say the next time it won’t get power. The starter will engage and spin the motor but the dash lights fuel pump ect won’t work. Can actually take the dess key out put the kill switch in the off position and...

I need help with fixxed my primary clutch on my renegade. I used clutch puller and I did damage on Crankshaft threads. I can't use a bolt because threads it's not good on my bolt and inside crankshaft. It can be fixed somehow? Thank you for your answers

I just bought my first fourwheeler. 19 850 xt. I’ve always rode 2 stoke bikes so I don’t know too much about wheelers. The outlander makes a slight kink noise in the engine when I get on and off the throttle. It doesn’t do it every time but does it often. Almost sounds like a belt catching or a...

Can anyone help me? I was out on my quad today and it fully submerged under the water but cut out straight away. It was in the water for about 2 mins, got the quad out the water put it on it’s back emptied the air box drained all the water out it back down took my spark plugs out the turned it...

I have an outlander 1000 that dies when I put water on spark plugs changed the boots and also put dielectric grease in them the old boots had cracks in them but was arcing against the block with the water and causing it to die and changing the boots and still having issues when water splashes on...

So, I just purchased a 2015 can-am outlander 800. My dealer told me to come in at 25 hours, even though can-am recommends a 10 hour service which they failed to mention. When I asked about the 10 hour service, they stuck to the 25 hours for the first service which I have in writing. My question...

Ok so a guy on Craigslist has a 2008 outty 800 for sale but it won't start. He claims he was riding it when it quit and now it want start back up. Said he replaced the fuel pump, fuel filter, ignition coil, plugs, and said it has 167 psi on the front cylinder and 160 in the back cylinder. Also...

check out the channel for some summer vids. but this is the latest since it snowed

Hello I am new to this forum and was wondering if you guys could help me with my problems. I have a 2006 Can Am outlander 650 that i just bought and it has an overheat problem. It overheats after about 30 minutes of riding it, also on initial startup it idles rough drops down to 1000rpn then...

Hey so i ride a 2007 can am outlander and my speedomete does not work anymore. it is not digital the only thing that works is the RPM gauge thats on the very bottom can any help me how to fix that?

So After rebuilding my 650 engine with new rod bearings and Cam chains it now decides it wants to leak oil :( so i guess i should get it done before the spring. Ive put paper underneath the bike to see if i can tell where its coming from and cleaned the engine off etc but cant tell,so im...

ok this maybe a dumb question but where do you fill the gear box with oil? i drained the oil out of the plastic bolt. not sure how much came out but now i am not where to put the new oil and how much. by the way i am working on a can am outlander 800. thanks for any help