Search Results for ‘can am renegade’

Okay guys so I have a 2016 renegade 1000 xmr. Is it possible to use a front brake caliper for the rear? I have a bad rear brake caliper and I have an extra front caliper so I’m wondering if the front one will work. It looks like it would bolt up completely the same. Everything looks to be the...

This is not my picture but these circled spots are lit on my renegade and there is moisture in the gauge and can’t tell what they are 2 on the right are green and one on the left is red can someone tell me what they mean?

Hi everyone, does anyone know the stock gas pressure for the 2020 can am renegade xxc 1000 fox podium 1.5 rc2 shocks? Im replacing the gas and oil in the front shocks.

I’ve got a 2018 Renegade that occasionally won’t start.. it will start 10x in a row then say the next time it won’t get power. The starter will engage and spin the motor but the dash lights fuel pump ect won’t work. Can actually take the dess key out put the kill switch in the off position and...

Hi, I'm from Romania, I have a renegade and a week ago my servo broke down, I put the contact on the ATV. it spins a little servo and after it stops it doesn't work anymore and it appears to me to check dps can you help me please

How can I mount a wetsounds stealth 6 on my can am renegades handlebars

I need help with fixxed my primary clutch on my renegade. I used clutch puller and I did damage on Crankshaft threads. I can't use a bolt because threads it's not good on my bolt and inside crankshaft. It can be fixed somehow? Thank you for your answers

I was wondering if anybody knew anywhere that i could get cheap :smilietwocents:aftermarket parts. anywhere that cuts out the middle men so i can just buy straight from the factory, or any companys that part out can ams. specifically stuff that fits a 2012 can am renegade 800.:aniwheeler6:

So, recently I have replaced the front U-joint, it is brand new, and there is still play in the joint, the differential bearing isn't bad, but something is, I've replaced two U-joints before due to they're worn out, I think my problem is that the drive shaft wore out because of when my U-joint...

When I first fire my atv up it idles really low, like 1000 RPM's causing it to stall.. it will idle at 1250 which is normal after a few seconds and run fine, any suggestions?

I finally decided to take a look inside the CVT and check things out... I started up my Machine and there is this loud ticking noise.. Is this normal? All stock Clutching, here's a video.

Going out for a ride this weekend and I came across some problems .. I noticed that my rear diff was leaking, like both of the seals went bad.. is that normal? Also when I got above speeds of about 50 MPH my RPM's would bog down to only about 6600 what would cause that? I noticed my air filter...

I was wondering if you could fit the XMR cvt exhaust on a 2011 renegade 500..