Search Results for ‘maintenance’

Tie rod end broke off the joint on the trail yesterday. I want to replace them with heim joints but due to the snow the supply store is closed. Found a lady on Facebook with complete tie rods for a 2018 Outlander 1000, would I be able to use those, or at least the ends on my 2011 G1 800R?

Hello, I bought used 2015 Outlander 500 XT. The throttle response is really slow on the bottom, the top seems fine. I have changed the spark plugs, battery and the belt, but still the same. Any advice on what to check? The engine has 500 hours on it. Is it time to change pistons? Was...

Hey, I'm a bit confused with what oil to get. For all season, the 2016 Manual says: Outside of US (P/N 619 590 114) Inside of US XPS 4-STROKE SYNTHETIC OIL (ALL CLIMATE) (P/N 293 600 112) Which one of those is on Can ams website lol? I don't see any part numbers...

Hello all, I'm sure something similar to this has been posted, but I couldn't find something exactly like what I'm looking for. If there is something please redirect me. Anyways, I'm looking to get a used ATV for around $5,500, could go a little more. I've seen some 2013 - 2014 Outlander 1000...

Hey guys, I just recently brought home my new 2017 Defender HD10 XT and I was doing some looking around at my owners manual and under the section of (Maintenance Schedule pg. 99) it says to "Adjust valve clearance" at either 100 hours/ 1,000 miles or 200 hours/ 2,000 miles depending on what...

Looking for any opinions, good or bad, on Michaels Reno Powersports or Michael's Cycle Works to have dealer maintenance performed i.e., valve I/A, CVT I/C/L, etc.

Just purchased a new 2014 Outlander 500 DPS in the fall of 2014. Finally put 10 hours on the bike, and my dealer wants me to bring it in for the 10 hour service; however they told me it was going to cost $800 and an additional $50 for a new air filter. Is this normally what the dealers charge...

I have a 2005 outlander 330 When it starts it idles but when giving it gas it dies?? Also when I turn the chock off it idles really high what should I do to fix this

Hello this is my first post as i just got an 05 outlander xt 4x4. After changing the differential oil, motor oil etc I decided to put a couple of pumps of grease in the grease certs of the u joints and found that a typical grease hose cant get in there..Is there some trick or special grease tool...