Can-Am ATV Forum banner

spacers

  1. Bear Claw HTR on Can Am Outlander

    ATV Tires and Wheels
    Hey everyone, I have learned a lot from reading other posts on this forum, but I have not found a good solution to my problem. I recently purchased a 2008 Can Am Outlander Max 800 XT that I am looking to put 27 inch Bear Claw HTRs on. The Bear Claws are too wide for the front and will rub the...
  2. Rims for 2008 Outlander Max with Bear Claw HTRs

    ATV Tires and Wheels
    Hey everyone, I have learned a lot from reading similar posts on this forum about wheels and tires, but I still have not been able to come to a final decision. I could use some advice on what to do next. I also am not sure what information is correct as I have read a lot of different data...
  3. 2011 XMR 800 Springs or Spacers?

    Can-Am XMR
    2011 XMR 800 Springs or Spacers? Hi I have a XMR 800 and the rear is riding low, what are my choices on correcting this? Is there after market springs? or just Spacers? I cannot afford those expensive shocks. Any help would be appreciated. Thanks
  4. Ebay Wheel Spacers

    ATV Tires and Wheels
    I recently purchased wheel spacers for my renegade on ebay through ASI Performance $56 for 2. They are 1.5" thick and appear to say APLUS offroad wheel spacers on the sides. They look nice and came with thread lock and lug nuts but when I mounted them I ran into some problems. First the studs on...
  5. Will the wheels fit?

    Can-Am Renegade
    I'm going with a maxxis bighorn 26X9-12 on the front 26X12-12 rear w/ 1.5inch spacer on a 2012 renegade 800R will the 12's clear the back shock because I have stock tire's on it now and look's verrry close?!
  6. Fox Shocks or Spacers

    Suspension
    Just curious to see if anybody has tried both and if there is a significant difference between the Fox Podiums and the Ruberdown Custom Spacers. I am sure the fox shocks would be better, but how much? I am trying to justify the cost of the shocks. I have the spacers now and if the ride is not...
  7. Anyone have advice on rear bearing swap?

    Can-Am Renegade
    Guys, I have a 2008 Rene 800x and yes it has spacers on it for my 27 inch Outlaws. The reason the right rear bearing went bad was the nut with the plastic insert broke apart and the nut backed off to the cotter pin allowing alot of movement and stress to the bearing. I did install a 5/8...
  8. Wheel Spacers ..

    Can-Am / BRP
    Guys what is your opinion about proper aluminum wheel spacers ,,, who uses them from you out there ? what wins on theadvantages disadvantages scale ? Im thinkig of installing a 1inch spacers on all whells on my 800r ... Manos The Greek
Top