Can-Am ATV Forum banner
wheel

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Can-Am DS
    The DS650x bolt pattern on the original wheels is 4/143 without a circle in the centre so how do you go about balancing such wheels I just changed tires and looks like i got one out of balance that likes to bounce the front of quad as you speed up needs balancing. I tried email local tire...
  2. ATV Tires and Wheels
    I recently purchased wheel spacers for my renegade on ebay through ASI Performance $56 for 2. They are 1.5" thick and appear to say APLUS offroad wheel spacers on the sides. They look nice and came with thread lock and lug nuts but when I mounted them I ran into some problems. First the studs on...
  3. ATV Tires and Wheels
    Normally when balancing a tire, a center hole is used, but on a lot of atv rims there is no center hole. Those that do get them balanced, how do you do it? I am cheap and haven't found a reasonably priced place with a wheel stud hole adapter plate to do them yet. After a little searching I came...
  4. ATV Tires and Wheels
    Recently put a set of No Limit Octane Wheels on the Outlander! They are very bad*** looking and very well made. So far of all the ATV rims I have owned these are the heaviest built. If your looking for something a little different from all your buddies rims look into these. A few nice things...
  5. Can-Am Outlander
    Hey all, I did some searching to see if someone had the same phenomenon as I did but no takers so I'm in search of either some advice or resolution. I have a new to me 07 outlander 800 xt (thing is beast!) and I was playing around in 4 wheel low for a while to get used to the machine as we just...
1-5 of 5 Results
Top