Can-Am ATV Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Guys I have had this quad since new and has maybe 12 hours on it.
Turn key on and try to start but the starter relay just clicks, put new starter and replaced all 3 relays under the front by the handle bars, checked all fuses and they are good.
What else could this be? Anything else to check? I have jumped the solenoid and it started once but wires were getting very hot and didn't want to burn up the harness.
Took to Family Powersports last year and it cost 1500 and it still never ran.


Ony can am I have ever owned and probably the last after this experience.
 

·
Registered
Joined
·
167 Posts
Check your battery voltage should be at least 12 volts or more when the engine is NOT running. If you don't have a VOLT/OHM Meter maybe you need to invest in one. They are worth every penny you spend on it.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
Check the voltage and I'm getting 3.4 and I know the battery needs to be replaced now. But at the relay I'm gettin 3.4 but at the starter I'm getting nothing..is this right?
 

·
Registered
Joined
·
167 Posts
Get a new Battery, Check Voltage on it, install it . Bet it cures your problem.
 
1 - 6 of 6 Posts
Top