Can-Am ATV Forum banner

4X4 actuator

1502 Views 1 Reply 2 Participants Last post by  awful knawful
I installed a new o-ring in my actuator and I had a heck of a time lining up the fork to the little shaft that engages the 4x4, I thought I had it as engaged it and the light came on. I went on a poker run on the weekend and the 4x4 did not engage, I think the light blinked a few times but that's it. Any advice on getting the fork lined up to the pin would be great.
Thanks
Status
Not open for further replies.
1 - 2 of 2 Posts
did you put it in 4x4 before removing? that is recommended. but i suppose if it wasn't working you couldn't.......
1 - 2 of 2 Posts
Status
Not open for further replies.
Top