Can-Am ATV Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Hi guys,

I have been looking all over the place for info on replacing the rotors on my Outty. Can't find ANYTHING. :th_smiliefrustrated

its a 2007 800 XT Ltd. all i can find is info on the brake pads. Has ANYONE done this? Seems like its an involved process, and so i don't wanna go into it blind, but i'd like to do a full brake job, not just a pad slap.

Thanks for any info.

T.
 

·
Registered
Joined
·
4,001 Posts
Yep, Race Driven.
 

·
Registered
Joined
·
24 Posts
Discussion Starter #5 (Edited)
Thanks for the info guys!

That's probably the way I'll go when I buy them. I like that you can buy all three in a kit and its not some hokey ebay reseller.

Can you guys who have used these tell me if they include a pretty good set of tear-down instructions? That's what I'm really after since I'm mechanically handy, but this'll be my first time doin this on a quad. AND until I got my Can-Am I had never seen rotors way up into the body frame. And that single perpendicular rotor in the rear about blew my mind!! So it looks pretty complicated.

T.
 

·
Registered
Joined
·
207 Posts
I think you're overthinking it. If you are even slightly handy you'll figure it out. Its not that hard of a job.
 
1 - 6 of 6 Posts
Top