Can-Am ATV Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Hey guys. Yet another clutch question. Got a 2011 renegade 800r xxc. Was gonna buy the dalton dbo800r kit. I run 27 inch reptiles on 14 tips. Just wondering if anyone runs a similar setup up and which spring etc they may use and or any suggestions. Thanks.
 

·
Registered
Joined
·
14 Posts
Discussion Starter #2
Well read enough about it that my eyes are bleeding. Think the only thing I may order differently is the tan spring. Rather have the lower engagement. Anyone have the tan and like it over the y/g?
 

·
Registered
Joined
·
1,179 Posts
I run the dbo800 w/tan spring 28" Zillas. I'm pleased.
 

·
Registered
Joined
·
1,263 Posts
the tan is good if u use ur machine around the house for yard work/plow/tow. little less herky jerky than g/y. the g/y has about a 2100 stall and I think the tan is like 1700? also good if ur a slow trail/rock crawl rider
 

·
Registered
Joined
·
1,179 Posts
I start moving at 1900. It is a smoother engagement than the stock setup.
 

·
Registered
Joined
·
14 Posts
Discussion Starter #6
Thanks for the replys, I'll probably get the kit and also by the tan spring to try. It was like when I bouht the new shoes, didn't realize I was opening such a can of worms. But I'm really enjoying working on and customizing it. I can't wait to try out this kit however.
 
1 - 6 of 6 Posts
Top