Can-Am ATV Forum banner

Custom 650xmr snorks

777 Views 5 Replies 3 Participants Last post by  iam_canadian22
5
Was getting bored waiting for the long weekend (normally first big rip of the year). Decided to paint the rad emblem and do some snorkels. Here's a few pics, not perfect and could do with a few tweaks but I am happy. Took a long time since I wanted it to be a take down so I can still access under the pod and take the rad cover off. Vehicle Automotive design Room Auto part Car
Land vehicle Vehicle Motor vehicle Tire Automotive tire

Machine Machine tool Auto part
Auto part Vehicle
Auto part Vehicle Machine
See less See more
Status
Not open for further replies.
1 - 6 of 6 Posts
Looks good, any pics of what you did to the pod? Im looking to do my own also and trying to figure out how to make the pod fairly easily removeable
5
looks good, any pics of what you did to the pod? Im looking to do my own also and trying to figure out how to make the pod fairly easily removeable
Auto part Vehicle Metal
Motor vehicle Automotive exterior Scrap Vehicle Auto part
Motor vehicle Automotive exterior Auto part Automotive tire Bumper
Yellow Auto part Automotive exterior Vehicle Bumper
Wire Auto part Fuel line Coil spring Electrical wiring
See less See more
3
looks good, any pics of what you did to the pod? Im looking to do my own also and trying to figure out how to make the pod fairly easily removeable
View attachment 27402 View attachment 27403 View attachment 27404 View attachment 27405 View attachment 27406
Under the pod was by far the hardest. I used inch and half to get it centered and once short stubbed out of the pod I used a 2" to 1 1/2 fernco. Forgot to take pics of difectly under it but I used 1 1/2 and just put it into the stock air intake after removing the twisted/shaped stock one. Hope the pics help, don't mind the chaulking job I was going for functionality not looks!! Auto part Vehicle
Vehicle Automotive exterior Auto part
Auto part Pipe Tire Engine Automotive engine part
See less See more
Thank you, good job
1 - 6 of 6 Posts
Status
Not open for further replies.
Top