Can-Am ATV Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi, everyone
New to this forum hoping someone can help me with my 2005 rally 200. Im trying to move the cover of the gear case. All the bolts are removed but having a hard time pulling it off. Any suggestions? Much appreciated!
 

·
Registered
Joined
·
1,573 Posts
Welcome to the site! There's not a lot of activity on here for those older rally's, that I've seen, but try posting your topic in the general/BRP area, you'll likely get more eye traffic than here.

That all being said, I remember the same struggle to remove a case off my boy's fourtrax 300. There were shafts that pressed into bearings on the inside of the case, made for a very tight fit, and a bit of a struggle to remove. Just make sure you're pulling/prying at an equal level, and not angling anything.
 
1 - 3 of 3 Posts
Top