Can-Am ATV Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I replaced my battery on my canam 2020 outlander. For one reason or another the the ATV would not start but wait a hour, without doing anything, then it would start. Figure that battery was going. I followed the manual to replace the battery, I’m not very mechanically inclined. Once I replaced the battery I have no power to the cluster or to the ignition. I did check the fuses, again via manual, and they were all good. Any help would be great, thanks!
 
1 - 4 of 4 Posts
Top