Got the lights yesterday. They look really nice. Tested them on a battery. Nice and bright! I got the holes drilled. Cleaned up the edges using a Dremel with a sandpaper drum bit. I was going to finish the install today, but I had to actually use my Outlander today to plow a bunch of snow.
2014 Outlander 400.
Some of my CVT cover bolt holes have had the thread stripped out of the engine block where they thread into to seal the clutch cover.
I’m gonna put some Heli-Coil’s in then.
Does any one here know the tread pitch of those bolts??
I recently changed my oil on my 2005 Outlander 400. The manual called for 3L but that only got me to the bottom line of the dipstick so I dumped 100Ml in it and started it to get the oil into the filter. Then I added more and more until it was at the top line (another 400 ml). I then drove it...
Hey guys, so I rode my for a full weekend a month back, and it’s been sitting since, I went to move it out of the garage and realized that I jump on the gas I’m only getting half power, not to sure what the issue is quiets yet, was wondering if anyone has had the same issue, I ran high octane...
Up until now I’ve had zero issues with my outty. It’s got just over 800 miles on it, a lot of just cruising around and some hunting but it’s not abused. I fired it up to go check the mail today and noticed that it runs fine but idles erratically and moves on it’s own in reverse. No clue if these...