Can-Am ATV Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
133 Posts
Discussion Starter #1
Getting some options out there. I am going to do a snorkel it and rad relocate kit. Witch one would you do first? (can only do one at this time)
 

·
Registered
Joined
·
120 Posts
Rad relocate. Take a good close look at how hard it is to get in there and clean. You almost have to remove the inner plastics to clean it. And even if you do, you can only get it about 70% clean unless you pull the radiator.


Sent from my iPhone using Tapatalk so please excuse my fat finger syndrome.
 

·
Registered
Joined
·
932 Posts
These things can go plenty deep in water without mods; but the rad is almost impossible to clean on the fan side. I did the rad relocate because my bike started overheating more and more. I was able to clean the front ok, but the mud has nowhere to go on the edges and packs in. After pulling the rad completely out and taking hours to get to it, no looking back, the relocate kit was ordered.
 

·
Registered
Joined
·
26 Posts
Definitely do the rad first



Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
120 Posts
You're only really gaining a few more inches with the snorkels... Like it was said above... The intakes on these machines are already relatively high for any ATV. And he'll be more limited when he's overhearing in limp mode like these are so notorious for.


Sent from my iPhone using Tapatalk so please excuse my fat finger syndrome.
 
1 - 7 of 7 Posts
Top