Can-Am ATV Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Hey guys I need some help! I have been thinking of trying a set of 29.5x10x14 terminators on my 1000 xmr and I was wondering if they would mount up nice on my stock itp ss312 rims??? Any help would be greatly appreciated!! Thanks!
 

·
Registered
Joined
·
823 Posts
They will mount up. I don't see a reason why they wouldn't although a 7" wheel would be preferred I don't see why you can't install a 10" wire tire on a 6" wheel. Worse case scenario the lugs will not sit square at the end of the tire because the 6" wheel will bulge the tire some.
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #3 ·
Yeah that's what I was thinking but maybe I'll just look at getting OL2S instead just to be on the safe side I would sure hate to mount terminators on and keep having the bead popping of or something but thanks anyway bud!
 

·
Registered
Joined
·
823 Posts
Yeah that's what I was thinking but maybe I'll just look at getting OL2S instead just to be on the safe side I would sure hate to mount terminators on and keep having the bead popping of or something but thanks anyway bud!
The bead has a better chance of staying on a thinner wheel then a wide one. 9" Tire on a 6" wide rim is what's recommended. Should look nice with OL2's all the way around.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top