New to the forum but not new to side-by-sides and turning wrenches......However, I need some help.....I have a 2012 Can Am Commander 1000 Limited with about 3K miles on it.....I bought it last spring to replace an old John Deere Gator on the farm. Long story short, last fall the one way bearing went out and I didn't get around to replacing it until about two weeks ago. Now, after I have the new bearings installed and it all back together, I have no high range on the transmission. The indicator shows that it is in high range but it clearly is not. I have adjusted the shifter cable and have it centered with the stick in neutral.....Anyone have any idea what I did wrong to cause this or any idea what is up with this?
unsquidly
- Status
- Status
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
