Can-Am ATV Forum banner

Transmission Issues

1850 Views 6 Replies 4 Participants Last post by  Dreamon
When I throw it in gear, quad goes by itself without me hitting the throttle.
Then when I come to a stop, I cannot change out of the current gear I am in (drive to neutral, let's say). I need to shut the engine off so the transmission can lock into gear.

02 quest 500

Any help? Thank you.
Status
Not open for further replies.
1 - 7 of 7 Posts
The one way bearing in your primary clutch is in need of service.
The one way bearing in your primary clutch is in need of service.
You think i should take the quad to a dealer, or a local shop who is experienced with quads?

Im just thinking if i need any special parts only available from the dealer.

Thank you
Not a terribly difficult job depending on your skill level.
  • Like
Reactions: 1
Idling too fast? Don't know about the Quest, but it affects a Traxter this way.
yep..check idle...........mine does this all the time.also,if you pull up on the choke ,the engine revs low,then slip in gear,and return choke to normal
Idle screw is borderline stalling. Thanks
1 - 7 of 7 Posts
Status
Not open for further replies.
Top