Can-Am ATV Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1 (Edited)
Ok so I have looked all over and don't understand the clutch kits to much. I have a 2009 renegade 800. I have 27inch sti black diamond xtr's on it 29lbs front 32lbs rear. I'm looking to get the bike to wheelie as easy or easier if possible than when it was stock. I ride mostly trails with a good amount of rutted out mud holes in a variety of spots and most of the time I go for them but they are just rutted out not thick mud. What would be the best clutch setup for me. I have read bout the Dalton with the tan spring instead of the G/Y. I'm looking for something that is going to get great torque right away to the wheels to wheelie and I don't mind to lose anything off the top end BUT I don't want to do something that could break anything on my bike like axles snapping or that. Thanks for all the info in advance. Oh also not planning on any more mods than this but maybe the skid plates.
 
1 - 1 of 1 Posts
Top