Hey guys, sorry I didnt make an introduction post but I really need help. I'm trying to fix my dad's 03 or 04 outlander 400 but I am completely baffled. The problem is with the starter/safety switch circuit. If I turn the key on, the starter kicks on automatically and stays on until I hit the brake or shift into gear. If I turn the key on in gear or with the brake depressed, it wont start on its own, but it also wont start if I press the start button either. I took the starter button apart and it is getting power and works correctly. I then went back to the starter relay and checked the wires. I pulled off the two small wires and confirmed the ground is grounding right and the power wire is coming on correctly, of course it is sending power when it is not supposed to, but it is working right. I cannot figure it out and im not a newbie to wiring, but I can really use some help here as I rather fix it myself instead of bringing it to the dealership. Also, I dont know if this matters, but the voltage regulator blew and tookout the stock speedo and head lights. I replaced the speedo, headlights and regulator and it woked just fine for a while, but the speedo didnt work after. It lights up and the gear lights work but it doesnt record speed nor does the odometer work. Any help is greatly appreciated. Thanks, Nick